Differences

This shows you the differences between two versions of the page.

--- 3d_printing_it_infrastructure [2021/06/23 13:04] – created sdh7
+++ 3d_printing_it_infrastructure [2022/02/03 22:15] (current) – sdh7
@@ Line 5: / Line 5: @@
 SLA printer already has its own web interface- tends to change IP address on occasion,
-One Pi 3 has been set up for Octoprint (via Octopi) connected to the Ultimate for now. Have a workflow going with Cura-> printer through Octoprint that seems decent.
+<del>One Pi 3 has been set up for Octoprint (via Octopi) connected to the Ultimate for now. Have a workflow going with Cura-> printer through Octoprint that seems decent.</del>
 Unfortunately, Octoprint only really directly supports one printer at a time (kind of lame, but I understand their reasons...)
@@ Line 19: / Line 19: @@
   * Scaling up just involves adding config to udev/container setup/HAProxy
   * Add in OctoFarm for overview of everything? https://octofarm.net/
+We've actually done a fair bit of this - see [[Octoprint]] for more details.