User Tools

Site Tools


3d_printing_it_infrastructure

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

3d_printing_it_infrastructure [2021/06/23 13:04]
sdh7 created
3d_printing_it_infrastructure [2022/02/03 22:15] (current)
sdh7
Line 5: Line 5:
 SLA printer already has its own web interface- tends to change IP address on occasion,  SLA printer already has its own web interface- tends to change IP address on occasion, 
  
-One Pi 3 has been set up for Octoprint (via Octopi) connected to the Ultimate for now. Have a workflow going with Cura-> printer through Octoprint that seems decent.+<del>One Pi 3 has been set up for Octoprint (via Octopi) connected to the Ultimate for now. Have a workflow going with Cura-> printer through Octoprint that seems decent.</del>
  
 Unfortunately, Octoprint only really directly supports one printer at a time (kind of lame, but I understand their reasons...) Unfortunately, Octoprint only really directly supports one printer at a time (kind of lame, but I understand their reasons...)
Line 19: Line 19:
   * Scaling up just involves adding config to udev/container setup/HAProxy   * Scaling up just involves adding config to udev/container setup/HAProxy
   * Add in OctoFarm for overview of everything? https://octofarm.net/   * Add in OctoFarm for overview of everything? https://octofarm.net/
 +
 +We've actually done a fair bit of this - see [[Octoprint]] for more details.
  
3d_printing_it_infrastructure.txt ยท Last modified: 2022/02/03 22:15 by sdh7