| Name | UV Curing Lamp |
|---|---|
| Owner | Makers' Alliance |
| Location | 3D Printing |
| Training needed | No |
| Hackable | No |
| Model | MelodySusie |
| Serial | UNKNOWN |
| Arrival Date | UNKNOWN |
| Working | Yes |
| Contact | Sam Harmon |
Current Status: Fully Functional
A UV lamp normally intended for gel nail polish, this device works pretty well for curing SLA 3D prints. It has a couple of timed modes - one is two minutes, the other 30 minutes. The 30 minute setting run a couple of times should be sufficient for curing most SLA prints.
May also be useful for UV glues and/or PCB exposure, but untested for these uses.
There is a spare UV bulb in with the SLA Printing Supplies.