=====UV Curing Lamp=====

^Name| UV Curing Lamp|
^Owner | Makers' Alliance |
^Location | 3D Printing |
^Training needed| No|
^Hackable| No|
^Model| MelodySusie|
^Serial| UNKNOWN|
^Arrival Date| UNKNOWN|
^Working| Yes|
^Contact| Sam Harmon|

Current Status: Fully Functional

A UV lamp normally intended for gel nail polish, this device works pretty well for curing SLA 3D prints. It has a couple of timed modes - one is two minutes, the other 30 minutes. The 30 minute setting run a couple of times should be sufficient for curing most SLA prints.

May also be useful for UV glues and/or PCB exposure, but untested for these uses.

There is a spare UV bulb in with the SLA Printing Supplies.

{{tag>[    needs_details]}}