=====Hot Wire Cutter=====

^Name| Hot Wire Cutter|
^Owner | Steve Gray |
^Location | Shop Zone |
^Training needed| yes|
^Hackable| no|
^Model| N/A|
^Serial| N/A|
^Arrival Date| 2014|
^Working| yes |
^Contact| Steve Gray|

Current Status: Original 1-2 A rectifier system replaced with 6A power supply and PWM regulator. Way more power than necessary. Wire gets red hot in a few seconds at 30-50% on the controller. 

A DIY'd hot wire cutter on loan from Steve. Uses a Craftsman router table as its table.

You'll know if it's still on, as it makes quite a hum when it's getting power. Unplug when not in use.

{{tag>[]}}