Differences

This shows you the differences between two versions of the page.

--- shapeoko [2017/01/13 04:44] – sdh7
+++ shapeoko [2018/07/27 15:50] (current) – sdh7
@@ Line 12: / Line 12: @@
 ^Contact| Sam Harmon|
-Current Status: Provisionally Working
+Current Status: Taken home (too loud to use in the current environment)
 In 2013, Sam purchased a Shapeoko kit. Made good progress at first, and then it languished in his garage for a few years.
@@ Line 21: / Line 21: @@
 Software: We are now using bCNC as the Gcode sender. It also has some CAM functionality.
-Another option for design/Gcode generation is Inventables' Easel software, which is made with the Shapeoko in mind. Design your part, export the Gcode, and load it into bCNC.
+Another option for design/Gcode generation is Inventables' [[http://easel.inventables.com|Easel]] software, which is made (partially) with the Shapeoko in mind. Design your part, export the Gcode, and load it into bCNC. Just tell it you're using a Shapeoko 1, and keep your design to about 6" (160-ish mm) square.
 ===To-Do List===
+  *Electronics needs to be better organized in a box with bulkhead connectors, etc.
   *Base: Drill holes in base to mount to whatever bench it will sit on
-  *Calibration: seems ok at the moment. Maybe double check with a dial indicator?
+  *Calibration: (1/17/17- X&Y were determined to be out of whack. Ran a 50mm square job and found it produced a 45-ish mm square. Read more documentation and found steps/mm for MXL belts should be 43.74 vs. the 40 it was set to. 50mm square carved correctly on the second run) X&Y good. Z TBD- need to design a job to mill out pockets of particular depths and check with a depth gauge. Also tricky to quantify since current workholding uses fairly spongy double-sided tape.
-  *Limit Switches: Use mechanical switches for X-/X+/Y-/Y+/Z+. Maybe build/buy a touch plate setup for Z-? Printed the base of a touch plate, and Steve will cut out a brass disc for it on his CNC router.
+  *Workholding- refer to [[http://www.shapeoko.com/wiki/index.php/Workholding|Shapeoko's wiki]] for more information/ideas- looking at  1/2" thick spoilboard with lots of threaded inserts at the moment.
-(X- & Y- switches are installed on 3D printed mounts. Additional T-nuts are needed to install X+ & Y+ switches.)
+  *Limit Switches: Use mechanical switches for X-/X+/Y-/Y+/Z+. Maybe build/buy a touch plate setup for Z-? Printed the base of a touch plate, and Steve will cut out a brass disc for it on his CNC router. (X- & Y- switches are installed on 3D printed mounts. Additional T-nuts are needed to install X+ & Y+ switches.)
 {{tag>[needs_calibration]}}