k40_laser_engraver
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
k40_laser_engraver [2018/11/07 18:46] – sdh7 | k40_laser_engraver [2018/11/12 22:04] – sdh7 | ||
---|---|---|---|
Line 9: | Line 9: | ||
^Serial| NA| | ^Serial| NA| | ||
^Arrival Date| 3/17/2018| | ^Arrival Date| 3/17/2018| | ||
- | ^Working| | + | ^Working| |
^Contact| Sam Harmon| | ^Contact| Sam Harmon| | ||
Current Status: Sort of operational (It's a K40...) | Current Status: Sort of operational (It's a K40...) | ||
+ | |||
+ | Specifications: | ||
+ | * Power output: 40 W (theoretically, | ||
+ | * Cutting area: Clamp area is 8" | ||
+ | * Coolant: currently a mix of distilled water and RV antifreeze (3:1 ratio), a few drops of algicide, and a few drops of dish soap. | ||
+ | * Exhaust: Fume extraction via a BOFA AD-Access fume extractor/ | ||
Fixes implemented: | Fixes implemented: | ||
Line 29: | Line 35: | ||
Usage: It's not ready for production jobs yet, so DON'T USE IT. We're getting there... | Usage: It's not ready for production jobs yet, so DON'T USE IT. We're getting there... | ||
+ | * How to format your SVG drawings for K40 Whisperer: https:// | ||
Safety considerations: | Safety considerations: | ||
Line 34: | Line 41: | ||
* NO PVC OR VINYL-BASED MATERIALS - Chlorine gas is bad for you! | * NO PVC OR VINYL-BASED MATERIALS - Chlorine gas is bad for you! | ||
* Wood and Acrylic are OK. ATX Hackerspace has a recommended list of materials [[http:// | * Wood and Acrylic are OK. ATX Hackerspace has a recommended list of materials [[http:// | ||
+ | |||
+ | Power levels: | ||
+ | * Wood (engraving) - 8% does a fine job on the random plywood pieces we've tested with. | ||
+ | * Acrylic - 25% was great for engraving, but slightly insufficient for cutting (the cut edges did snap off easily, though) | ||
+ | |||
Upgrades to consider in the near term: | Upgrades to consider in the near term: | ||
- | * Dedicated | + | * Dedicated |
* < | * < | ||
* Air assist (pump acquired, need to get tubing/ | * Air assist (pump acquired, need to get tubing/ | ||
- | * < | ||
* honeycomb base (http:// | * honeycomb base (http:// | ||
* < | * < |
k40_laser_engraver.txt · Last modified: 2021/07/13 23:24 by sdh7