k40_laser_engraver
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| k40_laser_engraver [2018/11/07 18:46] – sdh7 | k40_laser_engraver [2018/11/07 18:52] – sdh7 | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ^Serial| NA| | ^Serial| NA| | ||
| ^Arrival Date| 3/17/2018| | ^Arrival Date| 3/17/2018| | ||
| - | ^Working| | + | ^Working| |
| ^Contact| Sam Harmon| | ^Contact| Sam Harmon| | ||
| Current Status: Sort of operational (It's a K40...) | Current Status: Sort of operational (It's a K40...) | ||
| + | |||
| + | Specifications: | ||
| + | * Power output: 40 W (theoretically, | ||
| + | * Cutting area: roughly 4" | ||
| + | * Coolant: currently a mix of distilled water and RV antifreeze (3:1 ratio), a few drops of algicide, and a few drops of dish soap. | ||
| + | * Exhaust: Fume extraction via a BOFA AD-Access fume extractor/ | ||
| Fixes implemented: | Fixes implemented: | ||
k40_laser_engraver.txt · Last modified: 2021/07/13 23:24 by sdh7